Today, I specially compiled a detailed explanation of Xiaopei's smart water dispenser full of dry goods with pictures and texts!

unpack:
➀When you get a new water dispenser, first confirm whether the packaging is intact
There are 6 parts in the packaging of the water dispenser: the host, the filter element, the filter tray, the drinking tray, the base of the host, and the USB data cable.
➁ Unpack the filter element and soak the filter element in water for 5 minutes.
NOTE: Soak twice. This step is to fully activate the filter material of the filter element.
➂While waiting for the filter element to soak, take down the drinking tray counterclockwise and tear off the sticker on the drinking tray. Rinse drinking tray and filter tray.

Install
➀Add clean drinking water to the water storage tank Note: Do not exceed the MAX water level. The water level is marked on the barrel wall.
➁Put the filter tray back on the bucket. Note: The water outlet of the filter tray must be aligned with the water pump outlet. Otherwise it will affect the water effect.

➂Align the soaked filter element with the filter element tray, press down to install it, and then screw the drinking tray clockwise.
➃Take out the base, find the interface in the groove on the back, plug in the USB power cable, and lock the power cable in the card slot to prevent the power cable from falling off.
➄Put the installed bucket on the base, turn on the power, the water dispenser will automatically start up, pay attention to observe, the NORMAL light is on, and the water dispenser will start to gush out water.

Description of work status
Normal state: double-click the base button to switch modes, SAMRT mode is intermittent water, 3 minutes of water stop for 3 minutes, and then cycle;
NORMAL mode is continuous water discharge. No matter in which mode, the water dispenser will pressurize and spout water every 6 hours to push the floating hair.

Alert status:
➀When the water dispenser is short of water, the REFILL indicator light turns red to remind the water shortage, and the water dispenser automatically enters the standby state and stops dispensing water. After adding water, the REFILL red light goes out, and the water dispenser automatically resumes normal operation.
➁The FILTER indicator light is red, reminding to replace the filter element. At this time, disassemble the new filter element and install it after soaking (refer to the above soaking installation method for steps), then press and hold the button for 5 seconds until the FILTER red light goes out, NORMAL lights up, and the system starts to recalculate the filter element usage time.

Spare battery installation Use a screwdriver to open the battery compartment on the back of the base and install the battery. When there is a power failure, the BATTERY green light flashes, indicating that the spare battery is powering the water dispenser normally; the BATTERY red light indicates that the battery is low, reminding to replace the battery.

Note: When the water dispenser is not used for a long time, remember to remove the battery.